Coating plasticization process Spray the prepared paint on the surface of the sample and put it in a constant temperature drying oven, and heat it to (60;80)°C (not more than 80°C, otherwise the coating will bubble due to excessive water evaporation), and keep it for 20 minutes; Then increase the temperature to 120°C and keep it for 20 minutes.

Molybdenum disulfide 2.3 NDZ-311W 0. The steps are as follows:

(1) Weigh the required concentrated PTFE dispersion and stir at high speed;

(2) Add the required amount of tin bronze powder, molybdenum disulfide, chromium trioxide, polyphenylene sulfide resin, and stir at high speed;

(3) Add titanate coupling agent NDZ-311W slowly and stir;

(4) PTFE BBQ Mat Slowly add Foamaster III defoamer and stir;

(5) Slowly add Levelling 620 associative levelling agent and stir;

(6) Slowly add the film-forming aid alcohol ester twelve and stir.

Preparation: Use concentrated polytetrafluoroethylene dispersion as the base material, and add fillers (the fillers are dried through a 600-mesh screen) and additives. Levelling620 0.006 Alcohol ester twelve 0.7 Bronze powder 6.

Formula 1 (Single-layer Teflon coating) Polytetrafluoroethylene concentrated dispersion 100 Chromium trioxide FoamasterIII 0. Take it out and put it in a box-type resistance furnace for plasticization.Polyphenylene sulfide.