If it is stopped indirectly with a towel, the stitches will loosen when the sewing material is changed. When the stitch length is inconsistent, the chain stitch will become unstable; the towel stitch height is also inconsistent, the result of sewing is not ideal. Letters have a degree-biased column shape and also have a vertical-biased column shape. The teacher should stop making changes.

It is very easy to realize a pattern of hemming that is connected to the outside in a proper way. This kind of pulling force is lateral and not easy to see with the naked eye. Stretching and repairing can make the letters have the same height when embroidered on clothes.. In the vertical direction, the fabric will also be pulled together and make some exceptional letters appear shorter than the rest. When jumping from the beginning of the towel embroidery pattern, take two or three chain stitches before skipping stitches.

Therefore, the jump of the pattern in any place should be as short as possible (note: the stitches cannot be skipped by the entangling embroidery and the upper belt), and the stitch length must be consistent when making a pattern. The length of the stitch length should not be changed in the uniform pattern. This is stretch repair. If the stitches are skipped directly from the beginning of the towel embroidery, the embroidery thread will be taken up to spread the towel loop.

Otherwise, there will be jumpers, especially when the tangled rust and the upper belt are embroidered, the stitches will be piled up and the result will be unsightly. When the degree is biased toward the line, the high density will pull the lines together and make the letters look a little higher. This is because the embroidery needles move up and down during embroidery, and the base fabric is stretched to cause distortion, so the China Coiling Taping Embroidery Machines pattern is patterned. The abnormal letters are not equally high on the display.

When skipping stitches is necessary, some sewing materials will be deformed following the skipping. The larger supplement department requires more adjustments than the smaller supplement department. On weekdays, the change of its bias is greater than 90. This stretch interval is determined by the size of the supplement department.Embroidery pattern maker’s experience in plate making: the stitch length setting is different according to the thickness of the applied thread, the thickness of the sewing material and the stitch density required by the pattern. Prevent a sharp change in embroidery bias.

Usually use two or three needle chain stitches to realize the towel embroidery pattern. Letter patterns also need to be repaired. Do not set skip stitches when the pattern is embroidered, otherwise the towel loop will be caught by the needle. What the pattern maker has to do is to stretch the external supplements outward to connect with the edging, or adjust the edging slightly inward to connect with the outside

The individual heads of the computerized embroidery machine China Multifunction Mixed Embroidery Machine Suppliers do not rise or fall Check the C16 board, the valve output voltage, 0V when not working, if it exceeds 5V, replace the C16N board;

Manual air valve switch to see if it works, replace the air valve if it does not work; Computer embroidery machine maintenance tutorial: The sequin motor of the computerized embroidery machine does not lift Check whether the C15 board has 24V voltage and whether the wiring is loose.

The computer embroidery machine drops or cuts the thread after cutting The interference from the main board to the encoder is large, resulting in unstable wire cutting; Adjust the buckle fork; Adjust the knife position. The computerized embroidery machine does not produce one piece or two pieces on individual heads Check whether the DIP switch matches with the sequins;

Check whether the sequin motor lacks phase and whether there is voltage, if it is normal, replace the C16 board; Adjust the angle of the sequin bottom plate; If it is normal, replace the C15 board; Check whether the valve output is set above 0. The operation box of the computerized embroidery machine displays a white screen Check whether the 5V power supply from the main board to the operation box is normal; Check if the contact of the LCD connector is loose; Replace the industrial control board;