Considering the change of pleat height, especially when the pleats are set to have a large gap, one issue that needs to be considered is the height of the feed tray, which is impossible on mechanical knife creasing machines, creasing machines, and pleating machines.

The platen usually includes heating components, like The heater or machine discharge plate at the bottom.Folding machines, pleating machines, and pleating machines are used in the clothing industry. It is necessary to re-adjust the position of the top platen. After the top platen is loosened, the platen can generally be moved up and down by moving the fluted screw to the left and right until the correct position is found and there is a gap of the China Rhinestone Hot Mixed Embroidery Machines Manufacturers thickness of the medium.

Old-fashioned creasing machines, pleating machines, pleating machines and new creasing machines, pleating machines, The pleating machine is different. This extra The adjustment of the top platen increases the preparation time of the standard mechanical creasing machine, creasing machine, pleating machine or old creasing machine, creasing machine, and pleating machine, especially when the new media requirements are not known in advance.

Our new type of creasing machine, creasing machine, and pleating machine can adjust the height of the pleats through rapid mechanical adjustment, while the old creasing machine, creasing machine, and pleating machine do not have rapid mechanical adjustment In this case, it is necessary to move the blade at the bottom to a new position for every change in the height of the pleats and every adjustment when the height of the pleats is pre-adjusted.

Changed, however, the repositioning of the media feed height helps to ensure smooth material introduction. When adjusting parameters. The purpose is to guide the pleats from the top of the heating device to the back of the pleating blade. Changing the height of the pleats requires a lot of work. We usually see them in clothing factories